Jeep Cherokee (KL): To Set A Desired ACC Speed. To Cancel. To Turn Off
When the vehicle reaches the speed desired, push the
SET + button or the SET - button and release. The
EVIC/DID will display the set speed.
If the system is Set when the vehicle speed is below
20 mph (32 km/h), the Set Speed shall be defaulted to
20 mph (32 km/h). If the system is Set when the vehicle
speed is above 20 mph (32 km/h), the Set Speed shall be
the current speed of the vehicle. NOTE: ACC cannot be set if there is a stationary vehicle
in front of your vehicle in close proximity. Remove your foot from the accelerator pedal. If you do
not, the vehicle may continue to accelerate beyond the set
speed. If this occurs: The following conditions cancel the system: The system will turn off and clear the set speed in
memory if:To Set A Desired ACC Speed
To Cancel
To Turn Off
To Resume. To Vary The Speed Setting. Setting The Following Distance In ACC
Other materials:
Rear door waterdam. Rear door. Rear door restraint
Rear door waterdam
REMOVAL
(1) Remove door trim panel.
(2) Peel the waterdam from the door.
(3) Route the latch rods and wire harnesses
through the waterdam.
(4) Separate the waterdam from the door inner
panel.
INSTALLATION
(1) Route the latch rods and wire harnesses
through the water ...