
Jeep Cherokee
Owners Manual
Understanding the features of your vehicle » Garage door opener - if equipped
Before You Begin Programming HomeLink
Ensure your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmission
of the radio-frequency signal it is recommended that
a new battery be placed in the hand-held transmitter of
the device that is being programmed to the HomeLink
system.
To erase the channels place the ignition in the ON/RUN
position and push and hold the two outside HomeLink
buttons (I and III) for up 20 seconds, or until the red
indicator flashes.
NOTE:
- Erasing all channels should only be performed when
programming HomeLink for the first time. Do not
erase channels when programming additional buttons.
- If you have any problems, or require assistance, please
call toll-free 1-800-355-3515 or, on the Internet at
HomeLink.com for information or assistance.
More about «Garage door opener - if equipped»:
Before You Begin Programming HomeLink