Jeep Cherokee (XJ): Heating and air conditioning
Jeep Cherokee (XJ) 1984 - 2001 Service Manual > Heating and air conditioning
- Description and operation
- Accumulator. Blower motor. Blower motor relay
- Blower motor resistor. Blower motor switch. Compressor
- Compressor clutch. Compressor clutch relay. Condenser
- Dual function high pressure switch (4.0 L). Evaporator coil. Fixed orifice tube
- Heater and air conditioner. Heater and air conditioner control. Heater core
- High pressure cut-off switch. High pressure relief valve. Low pressure cycling clutch switch
- Refrigerant. Refrigerant lines. Refrigerant line couplers
- Refrigerant oil. Refrigerant system service port. Vacuum check valve
- Vacuum reservoir
- Diagnosis and testing
- A/C performance
- Blower motor. Blower motor relay. Blower motor resistor
- Blower motor switch. Compressor. Compressor clutch coil
- Compressor clutch relay. Dual function high pressure switch/high pressure cut-off switch. Heater performance
- Low pressure cycling clutch switch. Refrigerant system leaks. Vacuum system
- Service procedures
- Removal and installation
- Service warnings and precautions
- Accumulator. Blend-air door motor. Blower motor
- Blower motor relay. Blower motor resistor. Compressor
- Compressor clutch
- Compressor clutch relay. Condenser. Dual function high pressure switch/high pressure cut-off switch
- Ducts and outlets
- Evaporator coil. Fixed orifice tube. Heater-a/c control
- Heater-A/C housing
- Heater-A/C housing door
- Heater core. Liquid line. Low pressure cycling clutch switch
- Kick cover. Mode door vacuum actuator. Refrigerant line coupler
- Suction and discharge line. Vacuum check valve. Vacuum reservoir
- Specifications
BODY
...
Other materials:
Valve spring and seal. Cylinder head. Cylinder head
Valve spring and seal
This procedure can be done with the engine cylinder
head installed on the block.
REMOVAL
Each valve spring is held in place by a retainer
and a set of conical valve locks. The locks can be
removed only by compressing the valve spring.
(1) Remove the engine cylinder head ...