TRANSMISSION PARTS CLEANING AND INSPECTION
Clean the transmission components with solvent and dry them with compressed air only. Do not use shop towels or rags.
Blow compressed air through all oil feed passages and channels to be sure they are clear. Inspect the transmission components for wear and damage.
Replace components that are damaged or worn beyond the limits specified in the individual overhaul procedures.
Replace all O-rings, gaskets and seals. These components are not reusable. Also replace any snap ring that is distorted or damaged.
During overhaul assembly operations, lubricate the transmission components with Mopar Mercony automatic transmission fluid or petroleum jelly as indicated.
Petroleum jelly should be used to prelubricate thrust bearings, washers and races. It can also be used to hold parts in position during assembly.
Soak replacement clutch and brake pack components in transmission fluid for at least 30 minutes before installation.