Toyota
Jeep Cherokee
 Service Manual
Turn signal and hazard warning systems » Removal and installation
Combination flasher

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL

(1) Disconnect and isolate the battery negative cable.

(2) Remove the knee blocker from the instrument panel. Refer to Knee Blocker in the Removal and Installation section of Group 8E - Instrument Panel Systems for the procedures.

(3) Reach through the outboard side of the steering column opening to access and disengage the combination flasher wire harness connector retainer from the instrument panel diagnostics mounting bracket (Fig. 4).

Fig. 4 Combination Flasher Remove/Install
Fig. 4 Combination Flasher Remove/Install

1 - DIAGNOSTICS MOUNTING BRACKET
2 - DIAGNOSTICS SPLICE BLOCK
3 - INSTRUMENT PANEL COURTESY LAMP
4 - DATA LINK CONNECTOR
5 - OUTBOARD STEERING COLUMN OPENING
6 - COMBINATION FLASHER AND CONNECTOR

(4) Pull the combination flasher into the instrument panel steering column opening far enough to access the wire harness connector.

(5) Remove the combination flasher from the wire harness connector.

(6) Remove the combination flasher from under the instrument panel.

INSTALLATION

(1) Position the combination flasher under the instrument panel.

(2) Align the combination flasher terminals with the terminal cavities in the wire harness connector.

(3) Push in firmly on the combination flasher until the terminals are fully seated in the terminal cavities in the wire harness connector.

(4) Install the combination flasher wire harness connector retainer into the mounting hole of the instrument panel diagnostics mounting bracket.

(5) Install the knee blocker onto the instrument panel. Refer to Knee Blocker in the Removal and Installation section of Group 8E - Instrument Panel Systems for the procedures.

(6) Reconnect the battery negative cable.

    More about «Removal and installation»:

    Combination flasher

    Turn signal switch and hazard warning switch

    Jeep Cherokee Service Manual / Turn signal and hazard warning systems / Removal and installation / Combination flasher

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com