Toyota
Jeep Cherokee
 Service Manual
Instrument panel systems » Removal and installation
Glove box

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

ROLL DOWN

(1) Disconnect and isolate the battery negative cable.

(2) Open the glove box.

(3) Locate the two rubber stop bumpers on the upper edge of the instrument panel glove box opening (Fig. 16).

Fig. 16 Glove Box Stop Bumpers Remove/Install
Fig. 16 Glove Box Stop Bumpers Remove/Install

1 - GLOVE BOX OPENING UPPER REINFORCEMENT
2 - GLOVE BOX LATCH STRIKER
3 - STOP BUMPERS
4 - GLOVE BOX DOOR

(4) Remove the two glove box stop bumpers by sliding them downward and out of the slots in the instrument panel upper glove box opening reinforcement.

(5) Roll the glove box downward so that the stops molded into the glove box bin pass through the stop bumper slots in the instrument panel upper glove box opening reinforcement.

(6) Reverse the roll down procedure to roll the glove box back up into the instrument panel.

REMOVAL

(1) Disconnect and isolate the battery negative cable.

(2) Remove the three screws that secure the glove box hinge to the instrument panel lower glove box opening reinforcement (Fig. 17).

(3) Release the glove box latch.

(4) Remove the glove box from the instrument panel.

INSTALLATION

(1) Position the glove box to the instrument panel with the bin inserted in the glove box opening far enough so that the stops on each side of the glove box bin are located behind the rubber stop bumpers located on the instrument panel upper glove box opening reinforcement.

(2) Align the screw holes in the glove box hinge with the mounting holes in the instrument panel lower glove box opening reinforcement.

(3) Install and tighten the three screws that secure the glove box hinge to the instrument panel lower glove box opening reinforcement. Tighten the screws to 2.2 N·m (20 in. lbs.).

Fig. 17 Glove Box Remove/Install
Fig. 17 Glove Box Remove/Install

1 - GLOVE BOX
2 - LATCH
3 - SCREWS

(4) Reconnect the battery negative cable

    More about «Removal and installation»:

    Steering column opening cover

    Knee blocker

    Instrument panel center bezel

    Instrument panel accessory switch bezel

    Cigar lighter relay

    Cluster bezel

    Headlamp switch

    Instrument cluster

    Instrument cluster components

    Instrument panel top cover

    Glove box

    Glove box components

    Glove box latch striker

    Instrument panel end cap

    Instrument panel center support bracket

    Instrument panel assembly

    Jeep Cherokee Service Manual / Instrument panel systems / Removal and installation / Glove box

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com