Jeep Cherokee (KL): Hazard warning flashers

Jeep Cherokee (KL) 2014 - 2023 Owners Manual > What to do in emergencies > Hazard warning flashers

The hazard warning flasher switch is located in the switch bank below the radio screen.

Push the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Push the switch a second time to turn off the Hazard Warning flashers.

This is an emergency warning system and it should not be used when the vehicle is in motion. Use it when your vehicle is disabled and it is creating a safety hazard for other motorists.

When you must leave the vehicle to seek assistance, the Hazard Warning flashers will continue to operate even though the ignition is placed in the OFF position.

NOTE: With extended use the Hazard Warning flashers may wear down your battery.

    Previous pageWhat to do in emergencies

    ...

    Next pageIf your engine overheats

    In any of the following situations, you can reduce the potential for overheating your engine by taking the appropriate action. On the highways - slow down. In city traffic - while stopped, put ...

    Other materials:

    Diagnosis and testing
    Water leaks Water leaks can be caused by poor sealing, improper body component alignment, body seam porosity, missing plugs, or blocked drain holes. Centrifugal and gravitational force can cause water to drip from a location away from the actual leak point, making leak detection difficult. All ...