Jeep Cherokee Service ManualElectrically heated systems » Heated seat system » Removal and installation
Heated seat relay
Heated seat relay
(1) Move the right power seat adjuster to its full up and full rear stop positions.
(2) Disconnect and isolate the battery negative cable.
(3) Unhook the seat cushion cover retainer from the seat cushion frame and pull back the seat cushion cover.
(4) Pull back the seat cushion to allow access to the Heated Seat Relay.
(5) Cut the Christmas tree fastener to remove the Heated Seat Relay fastener from the mounting bracket. Unplug the wire harness connector from the relay (Fig. 3).
(6) Reverse the removal procedures to install. A new Christmas tree fastener must be used to mount the relay. Be certain that the relay terminals are aligned with the cavities in the wire harness connector before pushing the relay firmly into place.
Fig. 3 Heated Seat Relay Remove/Install
1 - HEATED SEAT RELAY
2 - SEAT CUSHION FRAME
3 - WIRE HARNESS CONNECTOR
4 - POWER SEAT TRACK FRONT BRACKET
Heated seat switch
Seat heat interface module
Heated seat relay
Jeep Cherokee Service Manual
- Lubrication and maintenance
- Suspension
- Differential and driveline
- Brakes
- Clutch
- Cooling system
- Battery
- Starting systems
- Charging system
- Ignition system
- Instrument panel systems
- Audio systems
- Horn systems
- Speed control system
- Turn signal and hazard warning systems
- Wiper and washer systems
- Lamps
- Passive restraint systems
- Electrically heated systems
- Power distribution systems
- Power lock systems
- Vehicle theft/security systems
- Power seat systems
- Power window systems
- Power mirror systems
- Chime/buzzer warning systems
- Overhead console systems
- Engine
Categories
