Toyota
Jeep Cherokee
 Service Manual
Horn systems » Removal and installation
Horn

REMOVAL

(1) Disconnect and isolate the battery negative cable.

(2) Raise and support the vehicle.

(3) Remove the front underbody splash shield.

NOTE: Remove the horn and its mounting bracket from the vehicle as a unit. Do not remove the horn from its mounting bracket.

(4) Remove the screw that secures the horn and mounting bracket unit to the radiator closure panel brace (Fig. 4).

Fig. 4 Horns Remove/Install
Fig. 4 Horns Remove/Install

1 - MOUNTING BOLT
2 - HORN

(5) Lower the horn and mounting bracket unit far enough to access and disconnect the wire harness connector from the horn connector receptacle.

(6) Remove the horn and mounting bracket unit from behind the front bumper

INSTALLATION

(1) Position the horn and mounting bracket unit behind the front bumper.

(2) Reconnect the wire harness connector to the horn connector receptacle.

(3) Position the horn and mounting bracket unit to the radiator closure panel brace.

(4) Install and tighten the screw that secures the horn and mounting bracket unit to the radiator closure panel brace. Tighten the screw to 28.5 N·m (21 ft. lbs.).

(5) Install the front underbody splash shield.

(6) Lower the vehicle.

(7) Reconnect the battery negative cable.

    More about «Removal and installation»:

    Horn relay

    Horn

    Jeep Cherokee Service Manual / Horn systems / Removal and installation / Horn

    Jeep Cherokee Service Manual

    Categories


    © 2017-2022 Copyright www.jcherokee.com