Toyota
Jeep Cherokee
 Service Manual
Suspension » Front suspension » Removal and installation
Hub bearing

REMOVAL

  1.  Raise and support the vehicle.
  2.  Remove the wheel and tire assembly.
  3.  Remove the brake caliper, rotor and ABS wheel speed sensor, refer to Group 5 Brakes.
  4.  Remove the cotter pin, nut retainer and axle hub nut (Fig. 8).

Fig. 7 Track Bar (LHD)
Fig. 7 Track Bar (LHD)

1 - NUT
2 - SUPPORT BRACKET
3 - LEFT FRAME RAIL
4 - STUD
5 - SCREW
6 - COTTER PIN
7 - NUT
8 - FRAME BRACKET
9 - NUT PLATE
10 - TRACK BAR
11 - BALL STUD END
12 - NUT

  1. Remove the hub bearing mounting bolts from the back of the steering knuckle. Remove hub bearing from the steering knuckle and off the axle shaft.

INSTALLATION

  1.  Install the hub bearing and brake dust shield to the knuckle.
  2. Install the hub bearing to knuckle bolts and tighten to 102 N·m (75 ft. lbs.).
  3.  Install the hub washer and nut. Tighten the hub nut to 237 N·m (175 ft. lbs.). Install the nut retainer and a new cotter pin.
  4.  Install the brake rotor, caliper and ABS wheel speed sensor, refer to Group 5 Brakes.
  5.  Install the wheel and tire assembly.
  6.  Remove support and lower the vehicle.
    More about «Removal and installation»:

    Shock absorber

    Coil spring/jounce bumper

    Lower suspension ARM

    Upper suspension ARM

    Front axle bushing

    Stabilizer bar

    Track bar

    Hub bearing

    Wheel mounting studs

    Jeep Cherokee Service Manual / Suspension / Front suspension / Removal and installation / Hub bearing

    Jeep Cherokee Service Manual

    Categories


    © 2017-2023 Copyright www.jcherokee.com