Toyota
Jeep Cherokee
 Service Manual
Steering » Power steering pump » Removal and installation
Power steering pump

NOTE: The power steering pump is mounted in the same position on LHD and RHD vehicles. On 4.0L RHD vehicles the front bracket is different. The service procedures are the same.

REMOVAL

(1) Remove serpentine drive belt, refer to Group 7 Cooling.

(2) Remove pressure and return hoses from pump, and drain pump.

(3) Remove 3 pump mounting bolts through pulley access holes.

(4) Loosen the 3 pump bracket bolts (Fig. 3) and (Fig. 4).

(5) Tilt pump downward and remove from engine.

(6) Remove pulley from pump.

INSTALLATION

(1) Install pulley on pump.

(2) Install pump on engine.

(3) Tighten pump bracket bolts to 47 N·m (35 ft.

lbs.).

(4) Install 3 pump mounting bolts and tighten to 27 N·m (20 ft. lbs.).

(5) Install the pressure and return hoses to pump.

(6) Install drive belt, refer to Group 7 Cooling.

(7) Add power steering fluid and perform Power Steering Pump Initial Operation.

    More about «Removal and installation»:

    Power steering pump

    Pump reservoir-2.5L

    Jeep Cherokee Service Manual / Steering / Power steering pump / Removal and installation / Power steering pump

    Jeep Cherokee Service Manual

    Categories


    © 2017-2022 Copyright www.jcherokee.com