Toyota
Jeep Cherokee
 Service Manual
Speed control system » Removal and installation
Servo cable

REMOVAL

(1) Disconnect negative battery cable at battery.

(2) Using finger pressure only, remove cable connector by pushing connector off the throttle body bellcrank pin (Fig. 4). DO NOT try to pull cable connector off perpendicular to the bellcrank pin. Connector will be broken.

(3) Two release tabs are located on sides of speed control cable at cable bracket (Fig. 4). Squeeze tabs together and push cable out of bracket.

(4) Unclip cable from cable guide at valve cover.

(5) Disconnect servo cable at servo. Refer to Speed Control Servo Removal/Installation.

Fig. 4 Speed Control Servo Cable at Throttle Body
Fig. 4 Speed Control Servo Cable at Throttle Body

1 - ACCELERATOR CABLE
2 - OFF
3 - OFF
4 - THROTTLE BODY BELLCRANK
5 - SPEED CONTROL CABLE
6 - RELEASE TABS
7 - BRACKET

INSTALLATION

(1) Attach end of cable to speed control servo.

Refer to Speed Control Servo Removal/Installation.

(2) Install cable into cable bracket (snaps in).

(3) Install cable connector at throttle body bellcrank pin (snaps on).

(4) Clip cable to cable guide at valve cover.

(5) Connect negative battery cable to battery.

(6) Before starting engine, operate accelerator pedal to check for any binding.

    More about «Removal and installation»:

    Speed control servo

    Speed control switch

    Servo cable

    Vacuum reservoir

    Jeep Cherokee Service Manual / Speed control system / Removal and installation / Servo cable

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com