Toyota
Jeep Cherokee
 Service Manual
Suspension » Front suspension » Removal and installation
Track bar

REMOVAL

  1.  Raise and support the vehicle.
  2.  Remove the cotter pin and nut from the ball stud end at the body rail bracket.
  3.  Use a universal puller tool to separate the ball stud from the frame rail bracket.

Stabilizer Bar (LHD)
Fig. 6 Stabilizer Bar (LHD)

1 - RETAINER
2 - GROMMET
3 - BUSHING
4 - CLAMP
5 - STABILIZER BAR
6 - LINK

  1. Remove the bolt and flag nut from the axle shaft tube bracket (Fig. 7).
  2.  Remove the track bar.

INSTALLATION

  1.  Install the track bar at axle tube bracket. Loosely install the retaining bolt and flag nut.
  2.  It may be necessary to pry the axle assembly over to install the track bar at the body rail. Install track bar at the body rail bracket. Install the retaining nut on the stud.
  3.  Remove the supports and lower the vehicle.
  4.  Tighten the retaining bolt at the axle shaft tube bracket to 54 N·m (40 ft. lbs.).
  5.  Tighten the ball stud nut to 81 N·m (60 ft. lbs.). Install a new cotter pin.
    More about «Removal and installation»:

    Shock absorber

    Coil spring/jounce bumper

    Lower suspension ARM

    Upper suspension ARM

    Front axle bushing

    Stabilizer bar

    Track bar

    Hub bearing

    Wheel mounting studs

    Jeep Cherokee Service Manual / Suspension / Front suspension / Removal and installation / Track bar

    Jeep Cherokee Service Manual

    Categories


    © 2017-2023 Copyright www.jcherokee.com