Toyota
Jeep Cherokee
 Service Manual
Engine » 4.0L engine » Removal and installation
Vibration damper

REMOVAL

(1) Disconnect negative cable from battery.

(2) Remove the serpentine drive belt and fan shroud. Refer to Group 7, Cooling Systems for the procedures.

(3) Remove the vibration damper retaining bolt and washer.

(4) Use Vibration Damper Removal Tool 7697 to remove the damper from the crankshaft (Fig. 58).

Fig. 58 Vibration Damper Removal Tool 7697
Fig. 58 Vibration Damper Removal Tool 7697

1 - VIBRATION DAMPER REMOVAL TOOL
2 - WRENCH

INSTALLATION

(1) Apply Mopar Silicone Rubber Adhesive Sealant to the keyway in the crankshaft and insert the key.

With the key in position, align the keyway on the vibration damper hub with the crankshaft key and tap the damper onto the crankshaft.

(2) Install the vibration damper retaining bolt and washer.

(3) Tighten the damper retaining bolt to 108 N·m (80 ft. lbs.) torque.

(4) Install the serpentine drive belt. (Refer to Group 7, Cooling Systems for the proper specifications and procedures).

(5) Connect negative cable to battery.

    More about «Removal and installation»:

    Engine mounts-front

    Engine mount-rear

    Engine assembly

    Intake and exhaust manifold

    Exhaust manifold-4.0L engine

    Cylinder head cover

    Rocker arms and push rods

    Valve springs and oil seals

    Cylinder head

    Valves and valve springs

    Hydraulic tappets

    Vibration damper

    Timing case cover

    Timing chain and sprockets

    Camshaft

    Camshaft bearings

    Crankshaft main bearings

    Oil pan

    Pistons and connecting rods

    Crankshaft oil seals-rear

    Oil pump

    Timing case cover oil seal

    Jeep Cherokee Service Manual / Engine / 4.0L engine / Removal and installation / Vibration damper

    Jeep Cherokee Service Manual

    Categories


    © 2017-2022 Copyright www.jcherokee.com