Toyota
Jeep Cherokee
 Service Manual
Transmission and transfer case » NV3550 manual transmission » Removal and installation
Yoke seal-2WD

REMOVAL

(1) Raise vehicle.

(2) Mark propeller shaft and axle yoke for alignment reference.

(3) Disconnect and remove propeller shaft.

(4) Remove old seal with Seal Remover C-3985-B (Fig. 10) from transmission housing.

1 - SPECIAL TOOL C-3985-B
2 - SEAL

INSTALLATION

(1) Place seal in position on transmission housing.

(2) Drive seal into transmission housing with Seal Installer C-3972-A (Fig. 11).

(3) Carefully guide propeller shaft slip yoke into housing and onto output shaft splines.

(4) Align marks made at removal and connect propeller shaft to rear axle pinion yoke.

Fig. 11 Installing Transmission Housing Yoke Seal
Fig. 11 Installing Transmission Housing Yoke Seal

1 - SPECIAL TOOL C-4171
2 - SPECIAL TOOL C-3972-A

    More about «Removal and installation»:

    Transmission

    Shift tower

    Yoke seal-2WD

    Rear housing yoke bushing

    Jeep Cherokee Service Manual / Transmission and transfer case / NV3550 manual transmission / Removal and installation / Yoke seal-2WD

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com