Jeep Cherokee (KL): Changing LaneSense Status

Jeep Cherokee (KL) 2014 - 2023 Owners Manual > Understanding the features of your vehicle > Lanesense > Changing LaneSense Status

The LaneSense system has settings to adjust the intensity of the torque warning and the warning zone sensitivity (early/late) that you can configure through the Uconnect system screen. Refer to "Uconnect Settings" in "Understanding Your Instrument Panel" for further information.

NOTE:

  • When enabled the system operates above 37 mph (60 km/h) and below 112 mph (180 km/h).
  • Use of the turn signal suppresses the warnings.
  • The system will not apply torque to the steering wheel whenever a safety system engages. (anti-lock brakes, traction control system, electronic stability control, forward collision warning, etc.).

    Previous pageLaneSense Operation. Turning LaneSense ON Or OFF. LaneSense Warning Message

    LaneSense Operation The LaneSense system is operational at speeds above 37 mph (60 km/h) and below 112 mph (180 km/h). The LaneSense system uses a forward looking camera to detect lane markings and ...

    Next pageParksense rear park assist

    The ParkSense Rear Park Assist system provides visual and audible indications of the distance between the rear fascia and a detected obstacle when backing up, e.g. during a parking maneuver. Refe ...

    Other materials:

    Driver side airbag module
    The following procedure is for replacement of a faulty or damaged driver side airbag module. If the driver side airbag has been deployed, the clockspring must also be replaced. Refer to Clockspring in the Removal and Installation section of this group for the additional service procedures for t ...