Jeep Cherokee

 Service Manual

Transmission and transfer case » AW-4 automatic transmission » Removal and installation
Gearshift cable

REMOVAL

(1) Shift transmission into Park.

(2) Remove shift lever bezel and necessary console parts for access to shift lever assembly.

(3) Disconnect cable at shift lever and feed cable through dash panel opening to underside of vehicle.

(4) Raise vehicle.

(5) Disengage cable eyelet at transmission shift lever and pull cable adjuster out of mounting bracket. Then remove old cable from vehicle.

INSTALLATION

(1) Route cable through hole in dash panel. Fully seat cable grommet into dash panel.

(2) Place the auto transmission manual shift control lever in "Park" detent (rearmost) position and rotate prop shaft to ensure transmission is in park.

(3) Connect shift cable to shifter mechanism by snapping cable retaining ears into shifter bracket and press cable end fitting onto lever ball stud.

(4) Place the floor shifter lever in park position.

Ensure that the pawl is seated within the confines of the adjustment gauge clip.

(5) Snap the cable into the transmission bracket so the retaining ears are engaged and connect cable end fitting onto the manual control lever ball stud.

(6) Lock shift cable into position by pushing upward on the adjusting lock button.

(7) Remove and discard the shift cable adjustment gauge clip from the park gate of the shifter.

Transmission and torque converter

Torque converter

Adapter housing seal

Speed sensor

Speedometer adapter

Speed sensor rotor-speedometer drive gear

Park/neutral position switch

Gearshift cable

Brake transmission shift interlock

Transmission valve body solenoids

Transmission valve body

Transmission control module

Solenoid harness adapter seal

Manual valve shaft seal

Accumulator pistons and springs

Second coast brake servo

Park rod and pawl

Transmission throttle cable

Oil pump seal