Jeep Cherokee (XJ): Removal and installation
Jeep Cherokee (XJ) 1984 - 2001 Service Manual > Transmission and transfer case > AW-4 automatic transmission > Removal and installation
- Transmission and torque converter
- Torque converter. Adapter housing seal. Speed sensor
- Speedometer adapter. Speed sensor rotor-speedometer drive gear. Park/neutral position switch
- Gearshift cable. Brake transmission shift interlock. Transmission valve body solenoids
- Transmission valve body. Transmission control module. Solenoid harness adapter seal
- Manual valve shaft seal. Accumulator pistons and springs. Second coast brake servo
- Park rod and pawl. Transmission throttle cable. Oil pump seal
Checking fluid level
(1) Be sure transmission fluid is at normal operating
temperature. Normal operating temperature is
reached after approximately 15 miles (25 km) of
operation.
(2) Position ve ...
Transmission and torque converter
REMOVAL
(1) Raise vehicle.
(2) Drain transmission fluid and reinstall oil pan
drain plug.
(3) On models with 2-piece fill tube, remove upper
half of tube (Fig. 45).
Fig. 45 Transmission ...
Other materials:
C-pillar trim. Quarter panel trim extension. Quarter panel trim and wheelhouse
cover
C-pillar trim
REMOVAL
(1) Remove the inner scuff plate.
(2) Remove the upper door opening trim.
(3) Remove the upper quarter panel trim.
(4) Remove the quarter panel trim extension.
(5) Remove the screws attaching the C-pillar trim
to the C-pillar (Fig. 68).
(6) Separate the C-pilla ...