Jeep Cherokee (XJ): Specifications. Special tools
The brake fluid used in this vehicle must conform
to DOT 3 specifications and SAE J1703 standards.
No other type of brake fluid is recommended or
approved for usage in the vehicle brake system. Use only Mopar brake fluid or an
equivalent from a
tightly sealed container.
CAUTION: Never use reclaimed brake fluid or fluid
from an container which has been left open. An
open container will absorb moisture from the air
and contaminate the fluid.
CAUTION: Never use any type of a petroleumbased
fluid in the brake hydraulic system. Use of
such type fluids will result in seal damage of the
vehicle brake hydraulic system causing a failure of
the vehicle brake system. Petroleum based fluids
would be items such as engine oil, transmission
fluid, power steering fluid, etc. Disc Brake Caliper Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Sliding Disc Brake Rotor Type . . . . . . . . . . . . . . . . . . . . . . . . . . Ventilated Brake Drum Size . . . . . . . . . . . . . . . . . . . . . . . . 9 in. or 10 in. Brake Booster Type . . . . . . . . . . . . . . . . . . . . . Dual Diaphragm DESCRIPTION TORQUE Brake Pedal Pivot Bolt/Nut . . . . . . . . . . . . 35 N·m (26 ft. lbs.) Brake Booster Mounting Nuts . . . . . . . . . . . 39 N·m (29 ft. lbs.) Master Cylinder Mounting Nuts . . . . . . . . . 17.5 N·m (155 in. lbs.) Combination Valve Mounting Nuts . . . . . . . . . 17.5 N·m (155 in. lbs.) Caliper Mounting Bolts . . . . . . . . . . . 15 N·m (11 ft. lbs.) Wheel Cylinder Mounting Bolts . . . . . . . . . . . . 10 N·m (7 ft. lbs.) Parking Brake Lever Screws . . . . . . . . . 10-14 N·m (7-10 ft. lbs.) BASE BRAKESSpecifications
Brake fluid
Brake components
Max. Runout . . . . . . . . . . . . . 0.12 mm (0.005 in.)
Max. Thickness Variation . . 0.013 mm (0.0005 in.)
Min. Thickness . . . . . . . . . . 22.7 mm (0.8937 in.)Torque chart
Brake Lines . . . . . . . . . . . . . 14 N·m (124 in. lbs.)
Brake Lines . . . . . . . . . . . . . 14 N·m (124 in. lbs.)
Brake Hose Bolt . . . . . . . . . . . 31 N·m (23 ft. lbs.)
Brake Line . . . . . . . . . . . . . 14 N·m (124 in. lbs.)
Lever Bracket Screws . . 10-14 N·m (7-10 ft. lbs.)
Cable Retainer Nut . . . . . . . 1.5 N·m (14 in. lbs.)Special tools

Other materials:
Fuel pump relay-pcm output. Idle air control (iac) motor-pcm
output. Radiator fan relay-pcm output
Fuel pump relay-pcm output
DESCRIPTION
The 5-pin, 12-volt, fuel pump relay is located in
the Power Distribution Center (PDC). Refer to the
label on the PDC cover for relay location.
OPERATION
The Powertrain Control Module (PCM) energizes
the electric fuel pump through the fuel pump relay.
T ...


