Jeep Cherokee (KL): Uconnect settings

The Uconnect system uses a combination of buttons on the touchscreen and buttons on the faceplate located on the center of the instrument panel that allow you to access and change the customer programmable features.

NOTE: Features can vary by vehicle.

Uconnect 5.0 Buttons On The Touchscreen And Buttons On The Faceplate
Uconnect 5.0 Buttons On The Touchscreen And Buttons On The Faceplate

1 - Uconnect Buttons On The Touchscreen

2 - Uconnect Buttons On The Faceplate

Uconnect 8.4A/8.4AN Buttons On The Touchscreen And Buttons On The Faceplate
Uconnect 8.4A/8.4AN Buttons On The Touchscreen And Buttons On The Faceplate

1 - Uconnect Buttons On The Touchscreen

2 - Uconnect Buttons On The Faceplate

Previous pageOil Change Reset. DID Selectable Menu Items

Oil Change Reset Oil Change Due Your vehicle is equipped with an engine oil change indicator system. The "Oil Change Due" message will display in the DID for five seconds after a single chime has s ...

Next pageButtons On The Faceplate

Buttons on the faceplate are located below the Uconnect system in the center of the instrument panel. In addition, there is a Scroll/Enter control knob located on the right side of the Climate Cont ...

Other materials:

Service procedures
Checking fluid level (1) Be sure transmission fluid is at normal operating temperature. Normal operating temperature is reached after approximately 15 miles (25 km) of operation. (2) Position vehicle on level surface. This is important for an accurate fluid level check. (3) Shift transmiss ...