Jeep Cherokee (KL): Green Telltale Indicator Lights. White Telltale Indicator Light

This indicator will illuminate when the park lights or headlights are turned on.

This indicator will illuminate when the front fog lights are on.

The instrument cluster arrow will flash independently for the LEFT or RIGHT turn signal as selected, as well as the exterior turn signal lamp(s) (front and rear) as selected when the multifunction lever is moved down (LEFT) or up (RIGHT).

NOTE:

• A continuous chime will sound if the vehicle is driven more than 1 mile (1.6 km) with either turn signal on.
• Check for an inoperative outside light bulb if either indicator flashes at a rapid rate.

This telltale will illuminate when the Stop/Start function is in "Autostop" mode.

The LaneSense indicator is solid green when both lane markings have been detected and the system is "armed" to provide visual warnings in the EVIC/DID and a torque warning in the steering wheel if an unintentional lane departure occurs. Refer to "LaneSense - If Equipped in "Understanding The Features Of Your Vehicle" for further information.

This light will turn on when the electronic speed control has been set.

When the LaneSense system is ON, the LaneSense indicator is solid white when only the left lane marking has been detected and the system is ready to provide visual warnings in the instrument cluster display if an unintentional lane departure occurs. Refer to "LaneSense - If Equipped in "Understanding The Features Of Your Vehicle" for further information.

This light will turn on when the electronic speed control is ON.

This will display the distance setting for the ACC system. Refer to "Adaptive Cruise Control (ACC)" in "Understanding The Features Of Your Vehicle" for further information.

This indicator shows when the Hill Descent Control (HDC) feature is turned on. The lamp will be on solid when HDC is armed. HDC can only be armed when the transfer case is in the "4WD LOW" position and the vehicle speed is less then 30 mph (48 km/h). If these conditions are not met while attempting to use the HDC feature, the HDC indicator light will flash on/off.

This indicator shows that the high beam headlights are on. Push the multifunction control lever away from you to switch the headlights to high beam. Pull the lever toward you to switch the headlights back to low beam.