Jeep Cherokee (XJ): Removal and installation
Jeep Cherokee (XJ) 1984 - 2001 Service Manual > Passive restraint systems > Removal and installation
- Driver side airbag module
- Driver side airbag module trim cover
- Passenger side airbag module
- Passenger side airbag door. Airbag control module. Clockspring
AIRBAG SYSTEM
NON-DEPLOYED
At no time should any source of electricity be permitted
near the inflator on the back of an airbag
module. When carrying a non-deployed airbag module,
the trim cover o ...
The following procedure is for replacement of a
faulty or damaged driver side airbag module. If the
driver side airbag has been deployed, the clockspring
must also be replaced. Refer to Clockspring ...
Other materials:
Valve springs and oil seals. Cylinder head. Valves and valve springs
Valve springs and oil seals
This procedure can be done with the engine cylinder
head installed on the block.
REMOVAL
Inspect the valve stems, especially the grooves. An
Arkansas smooth stone should be used to remove
nicks and high spots.
Each valve spring is held in place by a retainer
and ...