Jeep Cherokee (XJ): Removal and installation
- Engine mounts-front. Engine mount-rear. Engine assembly
- Intake and exhaust manifold
- Exhaust manifold-4.0L engine. Cylinder head cover. Rocker arms and push rods
- Valve springs and oil seals. Cylinder head. Valves and valve springs
- Hydraulic tappets. Vibration damper. Timing case cover
- Timing chain and sprockets. Camshaft. Camshaft bearings
- Crankshaft main bearings
- Oil pan
- Pistons and connecting rods
- Crankshaft oil seals-rear. Oil pump. Timing case cover oil seal
Service engine assembly (short
block). Hydrostatic lock. Engine oil service
Service engine assembly (short
block)
A service replacement engine assembly (short
block) may be installed whenever the original cylinder
block is defective or damaged beyond repair. It
consists o ...
Engine mounts-front. Engine mount-rear. Engine assembly
Engine mounts-front
The front mounts support the engine at each side.
These supports are made of resilient rubber.
REMOVAL
(1) Disconnect negative cable from battery.
(2) Raise the vehicle.
...
Other materials:
Valve springs and oil seals. Cylinder head. Valves and valve springs
Valve springs and oil seals
This procedure can be done with the engine cylinder
head installed on the block.
REMOVAL
Inspect the valve stems, especially the grooves. An
Arkansas smooth stone should be used to remove
nicks and high spots.
Each valve spring is held in place by a retainer
and ...