Toyota
Jeep Cherokee
 Service Manual
Transmission and transfer case » Automatic transmission-30RH » Removal and installation
Torque converter

REMOVAL

(1) Remove transmission and torque converter from vehicle.

(2) Place a suitable drain pan under the converter housing end of the transmission.

CAUTION: Verify that transmission is secure on the lifting device or work surface, the center of gravity of the transmission will shift when the torque converter is removed creating an unstable condition.

The torque converter is a heavy unit. Use caution when separating the torque converter from the transmission.

(3) Pull the torque converter forward until the center hub clears the oil pump seal.

(4) Separate the torque converter from the transmission.

INSTALLATION

Check converter hub and drive notches for sharp edges, burrs, scratches, or nicks. Polish the hub and notches with 320/400 grit paper or crocus cloth if necessary.

The hub must be smooth to avoid damaging the pump seal at installation.

(1) Lubricate converter hub and oil pump seal lip with transmission fluid.

(2) Place torque converter in position on transmission.

CAUTION: Do not damage oil pump seal or bushing while inserting torque converter into the front of the transmission.

(3) Align torque converter to oil pump seal opening.

(4) Insert torque converter hub into oil pump.

(5) While pushing torque converter inward, rotate converter until converter is fully seated in the oil pump gears.

(6) Check converter seating with a scale and straightedge (Fig. 70). Surface of converter lugs should be 1/2 in. to rear of straightedge when converter is fully seated.

(7) If necessary, temporarily secure converter with C-clamp attached to the converter housing.

(8) Install the transmission in the vehicle.

(9) Fill the transmission with the recommended fluid.

Fig. 70 Checking Torque Converter Seating
Fig. 70 Checking Torque Converter Seating

1 - SCALE
2 - STRAIGHTEDGE

    More about «Removal and installation»:

    Transmission

    Torque converter

    Yoke seal replacement

    Extension housing bushing

    Adapter housing

    Speedometer adapter

    Park/neutral position switch

    Gearshift cable

    Brake transmission shift interlock

    Valve body

    Output shaft rear bearing

    Governor and park gear

    Park lock

    Jeep Cherokee Service Manual / Transmission and transfer case / Automatic transmission-30RH / Removal and installation / Torque converter

    Jeep Cherokee Service Manual

    Categories


    © 2017-2022 Copyright www.jcherokee.com