Jeep Cherokee (XJ): Removal and installation
Jeep Cherokee (XJ) 1984 - 2001 Service Manual > Transmission and transfer case > Automatic transmission-30RH > Removal and installation
- Transmission
- Torque converter. Yoke seal replacement. Extension housing bushing
- Adapter housing. Speedometer adapter. Park/neutral position switch
- Gearshift cable. Brake transmission shift interlock. Valve body
- Output shaft rear bearing. Governor and park gear. Park lock
Fluid level check
Transmission fluid level should be checked monthly
under normal operation. If the vehicle is used for
trailer towing or similar heavy load hauling, check
fluid level and condition ...
CAUTION: The transmission and torque converter
must be removed as an assembly to avoid component
damage. The converter drive plate, pump bushing, or
oil seal can be damaged if the converter is left ...
Other materials:
Low pressure cycling clutch switch. Refrigerant system leaks. Vacuum system
Low pressure cycling clutch switch
Before performing diagnosis of the low pressure
cycling clutch switch, be certain that the switch is
properly installed on the accumulator fitting. If the
switch is too loose it may not open the Schrader-type
valve in the accumulator fitting, which will prevent ...