Jeep Cherokee (XJ): Disassembly and assembly

Previous pagePark rod and pawl. Transmission throttle cable. Oil pump seal

Park rod and pawl REMOVAL (1) Remove valve body as outlined in this section. (2) Remove bolts attaching park rod bracket to case (Fig. 88). (3) Remove park rod from manual valve shaft sector ...

Next pageTransmission

DISASSEMBLY (1) Remove torque converter. (2) Remove clamps attaching wire harness and throttle cable (Fig. 95) to transmission. Fig. 95 Typical Harness And Cable Clamp Attachment 1 - CLAMP ...

Other materials:

Compressor clutch relay. Condenser. Dual function high pressure switch/high pressure cut-off switch
Compressor clutch relay (1) Disconnect and isolate the battery negative cable. (2) Remove the cover from the Power Distribution Center (PDC) (Fig. 30). (3) Refer to the label on the PDC for compressor clutch relay identification and location. (4) Unplug the compressor clutch relay from t ...