Jeep Cherokee (XJ): Removal and installation
- Engine mounts-front. Engine mount-rear. Engine
- Intake manifold
- Exhaust manifold. Cylinder head cover. Rocker arms and push rods
- Valve spring and seal. Cylinder head. Cylinder head
- Hydraulic tappets. Vibration damper. Timing case cover oil seal
- Timing case cover. Timing chain and sprockets. Camshaft
- Camshaft pin replacement
- Camshaft bearings. Crankshaft main bearings. Oil pan
- Oil pump. Piston and connecting rod. Rear main oil seal
WARNING: NEW OR USED ENGINE OIL CAN BE
IRRITATING TO THE SKIN. AVOID PROLONGED OR
REPEATED SKIN CONTACT WITH ENGINE OIL.
CONTAMINANTS IN USED ENGINE OIL, CAUSED BY
INTERNAL COMBUSTION, CAN BE HA ...
Engine mounts-front. Engine mount-rear. Engine
Engine mounts-front
The front mounts support the engine at each side.
These supports are made of resilient rubber.
REMOVAL
(1) Disconnect negative cable from battery.
(2) Raise the vehicle.
...
Other materials:
Wiper motor. Wiper switch and washer switch. Washer system
Wiper motor
FRONT
(1) Disconnect and isolate the battery negative
cable.
(2) Remove the wiper arms from the wiper pivots.
See Wiper Arm in this group for the procedures.
(3) Remove the eight screws that secure the cowl
plenum cover/grille panel and screen to the cowl top
panel (Fig. 9).
...